Still a little unsure of exactly how this convenient tool works?

These Lean-Right Instructions should clear up any questions you still have.  However, if you have additional questions do

not hesitate to Contact Us.

1.      Motorcycle must be sitting on a level, hard surface such as a garage floor or

         level driveway.

2.      With motorcycle resting on jiffy stand, position the Lean-Right stand under

         the motorcycle with the hook resting on top of the left side tubular frame.

         (See Figure 1)

 

Figure 1

Figure_1.JPG

 

3.      Make sure the Lean-Right does not interfere with any part of the

         engine, transmission, or shocks by lifting up on the foot end to make sure the

         Lean-Right will rest against the bottom side of the right tubular frame.

         (See Figure 2)

 

Figure 2

Figure_2.JPG

 

4.      With the Lean-Right in the correct position, you can now lean the motorcycle

         to the right until it rests on the Lean-Right and is stable. (See Figure 3)

 

Figure 3

Figure_3.JPG

 

5.      Check the left side to make sure the Lean-Right is hooked on the left side of

         the tubular frame and the right side tubular frame is resting on the top part of

         the Lean-Right. (See Figure 4)

 

Figure 4

Figure_4.JPG

 

6.      Do not bounce the motorcycle on the Lean-Right (Could cause damage to

         the Lean-Right and the motorcycle).

 

7.      When finished with the motorcycle leaning to the right, lean it back to the

         left making sure it is resting securely on the jiffy stand and then remove

         the Lean-Right tool.

 

  • MAKE SURE TO REMOVE THE LEAN-RIGHT BEFORE MOVING THE MOTORCYCLE.
  • DO NOT SIT ON MOTORCYCLE WITH THE MOTORCYCLE RESTING ON THE LEAN-RIGHT STAND.
  • DO NOT ATTEMPT TO MOVE THE MOTORCYCLE WHILE RESTING ON THE LEAN-RIGHT.